Your remote control can be programmed to activate many devices, including gate operators, garage door openers, and commercial door openers.

Basic Programming Steps:

  • Locate the Learn button.
  • Garage door opener: Located on the back or side of the motor unit (you may have to remove the light lens). The Learn button may be green, orange, red, purple, or yellow with a small LED next to it.
  • Gate operator or commercial door opener: Located on the control or logic board, with a small LED next to it. Press and release your Learn button.
  • Within 30 seconds, press and hold the desired button on the remote control.
  • Press the remote control again when the opener lights blink. The operator or opener should activate. If not, repeat the steps.

 

In case you are looking for a garage door installation, Contact us at 612-400-9295 for a free on-site estimate!